Why the new Aston Martin is more than just a green Mercedes

This week's launch of Aston Martin’s new Formula 1 car was one of the most hyped events of the pre-season so far, as fans were intrigued by how the new-look AMR21 would be painted.

Listen to this article

While the livery did not disappoint, the car design itself also offered up some fascinating tweaks as the Silverstone-based team has evolved its race-winning RP20.

And, unlike the car launches that came before it, Aston Martin left very little to the imagination, releasing detailed shots of the entire car.

The first thing to note is that the team spent both of its development tokens on redesigning the chassis, in order that it could unlock aerodynamic performance from the central portion of the car.

This is, in part, a legacy of the team’s approach for 2020, having assimilated the overall design package of the previous year’s championship winning Mercedes including a more conventional position for the side-impact protection spars (SIPS).

Mercdes AMG F1 W10 side impact protection spar

Mercdes AMG F1 W10 side impact protection spar

Photo by: Giorgio Piola

The low-slung arrangement, as introduced by Ferrari in 2017, is now considered critical from an aerodynamic perspective, with the sidepod inlet positioned much like a periscope.

This is typically above the fairing that surrounds the SIPS, which is used to inhibit the turbulence created by the front tyre and therefore also aids the transit of cool air that’s supplied to the radiators within the sidepods.

Aston Martin AMR21 detail

Aston Martin AMR21 detail

Photo by: Aston Martin Racing

This image (above) depicts how the bargeboards are used to filter the turbulence created by the front tyre and convert it into something more usable. Meanwhile, the airflow fed from the front of the car, including the cape, is forced around the underside of the sidepod whilst the fairing around the SIPS shields the airflow entering the sidepod inlet.

This should result in a much cleaner flow arriving at the radiators, with the air having not been worked too hard by numerous surfaces en route.

The inlet itself is extremely narrow with the team recovering some of that with the sculpting on the sides of the chassis. The narrowness of the inlet also draws your attention to the substantial fin that grows out of the sidepod’s shoulder and helps to divert airflow down over the revamped sidepod packaging behind.

Aston Martin AMR21 detail

Aston Martin AMR21 detail

Photo by: Aston Martin Racing

This is an area where the team has clearly focused its resources, knowing that getting this right will reap aerodynamic rewards for other areas of the car.

The sidepod design draws inspiration from the new bodywork that the team installed in Mugello last season (below) but falls short of having the full ramp to floor transition, instead favouring the dipped midriff like we’ve seen adopted elsewhere.

Racing Point RP20 new sidepods detail

Racing Point RP20 new sidepods detail

Photo by: Giorgio Piola

The rear portion of the sidepods and the engine cover have extremely tight packaging, with the AMR21 akin to the W12 with the bodywork almost shrink wrapped to the componentry inside.

And, much like the W12, it also features a bodywork blister around the inlet plenum, a feature of the power unit which is believed to be bigger this season as a result of some of the performance and durability updates introduced by HPP.

The AMR12 also features a very small rear cooling outlet that not only shows how efficient they expect the Mercedes-AMG F1 M12 E Performance power unit to be, but also how much they have focused on producing a car that recovers the downforce lost by the introduction of the new regulations.

The extremely tight packaging creates a sizable undercut beneath the cooling outlet too, which buys back some of the floor that has been lost to the new regulations and drives home the performance of the coke bottle region.

Aston Martin AMR21 rear end detail

Aston Martin AMR21 rear end detail

Photo by: Aston Martin Racing

This is aided further by the token-free adoption of the Mercedes gearbox carrier and rear suspension from last season, an arrangement that Mercedes was particularly proud of because of the aerodynamic gains that it facilitates.

The new arrangement sees the suspension elements lifted clear of the diffuser ceiling, which has become more prominent as the teams push the boundaries of the regulations, while the rear leg of the lower wishbone being positioned so far back also results in the ability to extract more performance from the diffuser.

Mercedes AMG F1 W11 rear brakes duct detail

Mercedes AMG F1 W11 rear brakes duct detail

Photo by: Giorgio Piola

Diffuser rules

Diffuser rules

Photo by: Giorgio Piola

Mercedes AMG F1 W11 rear suspension

Mercedes AMG F1 W11 rear suspension

Photo by: Giorgio Piola

Aston Martin is the first team to unmask all the aerodynamic tricks it will use to make up the difference on the edge of the diagonal floor cut-out.

The first of these tricks shares a similarity to the design shown by AlphaTauri, with a trio of outwardly directed fins installed just behind the point where the floor starts to taper in.

Aston Martin AMR21 floor detail

Aston Martin AMR21 floor detail

Photo by: Aston Martin Racing

The airflow structures emitted from these fins will undoubtedly interact with the AlphaTauri-esque floor scroll and floor notch just ahead of them and help to mitigate some of the losses that have been created due to fully enclosed holes being outlawed and the reduced floor width ahead of the rear tyre.

It’s here where we find a solution akin to the one that Ferrari tested at the end of 2020 too, as a series of fins form an arc. This should help influence the airflow ahead of the rear tyre and reduce the impact that tyre squirt has on the diffuser.

Interestingly, it has also added two offset floor strakes inboard of this where teams normally only opt for one strake, with Mercedes in the pre-hybrid era being an advocate of such designs.

Aston Martin AMR21 detail

Aston Martin AMR21 detail

Photo by: Aston Martin Racing

A new solution appears on the rear wing too, as the thickness of the upper front corner of the endplate has been altered to allow for another upwash strike. Teams had already started to look for ways to redesign this region last year, with the removal of the louvres in 2019 resulting in an increase in drag.

The upwash strike is positioned in order that it can affect the tip vortex that’s generated by the top flap and endplate juncture and will undoubtedly be a design aspect that the rest of the field will take note of.

One standout omission...

Aston Martin AMR21 rear suspension and brakes detail

Aston Martin AMR21 rear suspension and brakes detail

Photo by: Aston Martin Racing

2021 brakes fins rule

2021 brakes fins rule

Photo by: Giorgio Piola

While Aston Martin did show us a lot of its new car, it did keep one element secret for now – the rear brake ducts (not pictured, above).

It does seem like a strange omission given it has shown us so much around the rest of the car but we must remember that this is one aspect of the 2021 cars that’s affected by the new regulations.

Perhaps the team feels it has found a small pocket of performance in that regard and doesn’t want to unnecessarily hand its rivals a chance to see it ahead of testing.

shares
comments

F1 sprint race plan still has issues to resolve - Aston Martin

Aston Martin reveals new F1 safety and medical cars for 2021

Assessing Hamilton's remarkable decade as a Mercedes F1 driver

Assessing Hamilton's remarkable decade as a Mercedes F1 driver

Prime
Prime
Formula 1
Alex Kalinuackas

Assessing Hamilton's Mercedes stint Assessing Hamilton's remarkable decade as a Mercedes F1 driver

Why new-look Haas is a litmus test for Formula 1’s new era

Why new-look Haas is a litmus test for Formula 1’s new era

Prime
Prime
Formula 1
Jonathan Noble

Why new-look Haas is a litmus test Why new-look Haas is a litmus test for Formula 1’s new era

The Mercedes F1 pressure changes under 10 years of Toto Wolff

The Mercedes F1 pressure changes under 10 years of Toto Wolff

Prime
Prime
Formula 1
Alex Kalinauckas

Assessing Wolff's Mercedes influence The Mercedes F1 pressure changes under 10 years of Toto Wolff

The all-French F1 partnership that Ocon and Gasly hope to emulate

The all-French F1 partnership that Ocon and Gasly hope to emulate

Prime
Prime
Formula 1
GP Racing

The line-up Ocon, Gasly may emulate The all-French F1 partnership that Ocon and Gasly hope to emulate

Who were the fastest drivers in F1 2022?

Who were the fastest drivers in F1 2022?

Prime
Prime
Formula 1
GP Racing

Who were the fastest F1 drivers? Who were the fastest drivers in F1 2022?

Nico Hulkenberg: Why F1's nearly man is refreshed and ready for his return

Nico Hulkenberg: Why F1's nearly man is refreshed and ready for his return

Prime
Prime
Formula 1
Adam Cooper

Why Hulkenberg is ready for return Nico Hulkenberg: Why F1's nearly man is refreshed and ready for his return

Why Vasseur relishes 'feeling the pressure' as Ferrari's F1 boss

Why Vasseur relishes 'feeling the pressure' as Ferrari's F1 boss

Prime
Prime
Formula 1
Jonathan Noble

Why Vasseur relishes the pressure Why Vasseur relishes 'feeling the pressure' as Ferrari's F1 boss

The crucial tech changes F1 teams must adapt to in 2023

The crucial tech changes F1 teams must adapt to in 2023

Prime
Prime
Formula 1
Jake Boxall-Legge

F1 2023's crucial tech changes The crucial tech changes F1 teams must adapt to in 2023